MY MUNNY'S HEAD WONT DRY OUT!

manoverboa · **Joined:** Sat Jun 30, 2012 6:21 am **Posts:** 1

I washed my munny's head but soap and water got inside, and now it wont dry out

ShadoeDelgado · **Posted:** Sat Jun 30, 2012 3:28 pm

I had the same problem, but I cut off the ears of my munny and got it out that way. You might be able to get it out by cutting a small hole in one of the hidden areas under the head if you're really adamant about getting it out. I'm sure it will dry out eventually.HIndsight 20/20, I'd suggest plugging up the hole next time with tape, gum, kneaded eraser..etc. I hope this helps

~Shadoe

DannyWilkes · **Posted:** Sat Jun 30, 2012 10:11 pm

just pop the head off!

it goes right back on....

TO_designs · **Joined:** Sat Oct 01, 2011 8:24 pm **Posts:** 2406

DannyWilkes wrote:

just pop the head off!

it goes right back on....

the plug goes up into the head ...so it still wouldnt drain with the head off lol

drill a hole into the flat part on the bottom of the head and you should be good

DannyWilkes · **Posted:** Sun Jul 01, 2012 2:33 am

it had to get in somehow so there much be some sort of outlet for it. i know how it works silly. pop the head off and if you have to drill a hole do it up inside that lol plughole it has.

TO_designs · **Joined:** Sat Oct 01, 2011 8:24 pm **Posts:** 2406

DannyWilkes wrote:

it had to get in somehow so there much be some sort of outlet for it. i know how it works silly. pop the head off and if you have to drill a hole do it up inside that lol plughole it has.

yeah the water got through the plug hole in the head ...the bottom of the head itself sits lower than the plug hole so not all the water will drain out ....if i have to take a picture i will lol ...there will still be about an inch of water that wont drain because the only hole in the head is about an inch above the base of the head ...you would have to drill a hole next to the plug opening to get the water out properly

Kidrobot Discussion Boards

MY MUNNY'S HEAD WONT DRY OUT!

Who is online